RUGGED DISPLACEMENT SENSOR
HIGH ACCURACY AND RESOLUTION
WATERPROOF UP TO 5 MPA
The JM series of vibrating wire (VW) displacement transducers are used to measure movements at joints and cracks in structures and foundations (concrete, rock, soil)
The JM utilizes a vibrating wire sensor attached to a spring tensioned between two anchors. Any variation of distance between these anchors will change the tension in the wire. The sensor is protected by a sliding stainless steel housing.
3 models are available:
The JM-S Crackmeter is attached to the surface of the structure using groutable or bolt-on anchors. Ball joints at each end of the sensor compensate for any anchor misalignment. The JM-S is also available in 3-D configuration for measurement in three orthogonal directions, or with special clamps for installation on a geogrid.
The JM-E Embedment Jointmeter is embedded in concrete structures such that its active length spans the construction joint to be monitored. This model consists of two sections: the socket and the sensor, which are installed and connected during two successive concrete lifts.
The JM-T is used in Borehole Extensometers.
A thermistor is integrated to the JM allowing temperature measurement.
|
Range |
25, 50, 100, 150, 2001, 2501, 3001 mm |
|
Overrange |
1.00 × range |
|
Accuracy |
± 0.25 % F.S. (± 0.1 % in option) |
|
Resolution |
0.02 % F.S. (min.) |
|
Operating temperature |
−20 °C to +80 °C |
|
Thermistor |
3 kΩ |
|
Cable |
IRC-41A, IRC-41AP, IRC-3902, IRC-21A (JM-T) |
|
Length ‘A’ of JM-S (mid-range) |
289.5, 357, 500, 651, 797, 933, 1076 mm |
|
Length ‘A’ of JM-T (mid-range) |
230.5, 298, 442, 593, 738, 875, 1018 mm |
|
Length of JM-E (at rest) |
383, 432, 602, 772 mm |
|
Diametre of JM-E (flanges) |
47.6 mm |
Please specify:
Optional accessories:
